Teka EX/60 Manual de usuario

Instructions for the installationand advice for the maintenanceEX/60 4G AI FUND EX/70 5G AI TR FUND - EX/70 5G AI AL TR FUNDInstructions ManualE

10CONVERSIONS10) REPLACING THE INJECTORSThe burners can be adapted to different types ofgas by mounting injectors suited to the type of gasin question

11SERVICINGAlways disconnect the appliance from theelectricity and gas mains before proceedingwith any servicing operation.11) REPLACING HOT PLATE PAR

12SERVICINGGas hot plate H05 RR - F Section 3 x 0.75 mm2TYPE OF HOT PLATE TYPE OF CABLESINGLE - PHASEPOWER SUPPLYCABLE TYPES AND SECTIONSATTENTION!!!I

13TECHNICAL DATA ON THE DATA LABEL5 BURNERSCATEGORY = II2H3+G30 - BUTANE = 28 - 30 mbarG31 - PROPANE = 37 mbarG20 - NATURAL = 20 mbarΣ Qn LPG Gas Rate

14TECHNICAL DATA FOR THE APPLIANCE GAS REGULATIONBefore leaving the factory, this appliance will have been tested and regulated by expert and speciali

15TEKA GROUPCOUNTRY CITY COMPANY CC PHONE FAXAustria Wien KÜPPERSBUSCH GES.M.B.H. 43 1 - 86680-20 1 - 86680-82Chile Santiago de Chile TEKA CHILE S.A.

21 Ultra rapid burner of 3100 W2 Rapid gas burner of 2800 W3 Semirapid gas burner of 1750 W4 Auxiliary gas burner of 1000 W5 Enamelled steel pan

1) BURNERSA diagram is screen-printed above each knob onthe front panel. This diagram indicates to whichburner the knob in question corresponds. After

4USENotes:Use of a gas cooking appliance produces heat and moisture in the room in which it is installed. Theroom must therefore be well ventilated by

5CLEANINGIMPORTANT:Always disconnect the appliance from the gasand electricity mains before carrying out anycleaning operation.2) HOT PLATEPeriodicall

6INSTALLATIONTECHNICAL INFORMATION FOR THE INSTALLERInstallation, adjustments of controls andmaintenance must only be carried out by aqualified engine

7IMPORTANT INSTALLATIONINSTRUCTIONS The installer should note that the appliance thatside walls should be no higher than the hot plateitself. Furtherm

88) ELECTRICAL CONNECTIONThe electrical connections of the appliancemust be carried out in compliance with theprovisions and standards in force.Before

9ADJUSTMENTSAlways disconnect the appliance from theelectricity main before making any adjustments.All seals must be replaced by the technician atthe